Recent content by fearhk213

pm'd

You Sir saved the day :rock: For some reason it didn't pass validation. I clicked validate & now it's golden. Thanks for both you guys' input.

Ok, this has me ready to beat my head into a wall. I cannot get Trigger to show up in Logic. I've still intouch with Slate support, but we haven't been able to figure out the issue. I have an intel iMac (general specs are fine for Trigger) & run Logic Express 7.2. I downloaded the latest...

Cool. Thanks for the info. I didn’t have time to track anything yesterday, but I had to at least slap the “s-preshigh” on an older track just to hear it. There was a noticeable increase in the swell of the low end, but I just bumped the high pass up 10hz and that took care of it. I really...

I have a question since I'm pretty new to this whole impulse thing.... With the AxeFx the general consensus is if you use it with a "colored" tube power amp (i.e. vht, mesa, ect), you should turn off the power amp sim in the AxeFx to avoid losing clarity since the power amp sim & real power...

Awesome! Thanks dude!

Cool, thanks man.

Cool tip! I'd heard of this before, but never heard it explained. Thanks! So if I have passive speakers and I run speaker wire w/the ends bare would I only need to take the left monitor and switch the wires at the "+" & "-" posts at that monitor? Sounds easy enough.... Do you have to...

When do you guys apply hi & lo pass filters to guitars? Do you dial in your tone with your amp's controls and mic placement and then add the filters after you're done tracking and ready to start mixing? Or, do you set the filters in place before you track and use them to help dial in your tone...