- Jun 24, 2012
- 75
- 0
- 6
Hey guys!
I've had this unit for like a month but I have a question to ask, cuz the manual doesn't give me the right answer.
Can you have one cable (cab cable of course) going out from ONE of the "mono" outputs (in mono bridge mode) and stick it into a 4ohm input on a cab?
Because I have a 4x12 Marshall. And it has 2 modes. 16ohm - Stereo, and 4ohm Mono. And if i want to use my Rocktron Velocity 300 in bridge mono, which I do cuz I only have one cab (?), is this the right way to hook it up?
There are 2 mono outputs on the back of the Velocity, but is it ok to just use one of them and go into a 4ohm input on the Marshall? The manual says that bridge mono is 300w, but is that if you have both outputs on from the back? Or does that apply to just one of them?
I might confuse you guys here.. but the question is: Can I run ONE cable out of ONE of the mono outputs, into the 4ohm input of my cab?
Thanks!
I've had this unit for like a month but I have a question to ask, cuz the manual doesn't give me the right answer.
Can you have one cable (cab cable of course) going out from ONE of the "mono" outputs (in mono bridge mode) and stick it into a 4ohm input on a cab?
Because I have a 4x12 Marshall. And it has 2 modes. 16ohm - Stereo, and 4ohm Mono. And if i want to use my Rocktron Velocity 300 in bridge mono, which I do cuz I only have one cab (?), is this the right way to hook it up?
There are 2 mono outputs on the back of the Velocity, but is it ok to just use one of them and go into a 4ohm input on the Marshall? The manual says that bridge mono is 300w, but is that if you have both outputs on from the back? Or does that apply to just one of them?
I might confuse you guys here.. but the question is: Can I run ONE cable out of ONE of the mono outputs, into the 4ohm input of my cab?
Thanks!
