Recent content by Erocku

Bogner Ecstasy

Awesome. I can't wait for a LE456 and LeCab port!!!

My RG1527 is in Drop A# with 10-59's and the saddle on A# is almost all of the way back.

Block the bridge, tune up and lock down the nut. Unblock the bridge and tighten the springs until it flattens out. If there's not enough tension with the springs tightened all of the way, add an additional spring and/or stronger springs.

Same here. Now I just need some LSD.

http://www.hearos.com/earplugs/music

The pod is going to require alot of EQ shaping to get distorted sounds to sound decent. If you are wanting those patches to sound great "live", having the pro model and throwing an EQ in the loop works wonders. I've heard good djenty sounds from people using the big bottom amp. Treadplate and...

All prices include shipping. Mesa Mark III+ . Very clean and loaded with graphic EQ, pentode/triode switch, and simul-class. It's a blue stripe model. The III+ mod was done by Mike B. at Mesa. It has the R2 volume mod done (Adds a volume control for the second channel so all 3 channels are...

I am downsizing from my Bogner 4x12 to this: It should be here Wednesday!

I dont need my logo on my 6505+ if you're interested.

Been following this project for a while now. I loved "The Serpent", but found out about Still Remains a little to late. I've been jammin' those two AA tracks for a lil while now. Can't wait to hear some vocals with it!!!

My band will be ready to do some recording in the next few months. I was just looking to see if there are any sneapster's that run a studio in or around Houston or if you can recommend anyone in the area.

Ok, so instead of resistors by the board, I should do this... But it looks like I had the general idea right.

Yeah, I couldn't see anyway to get a read from a single tube or pair without cutting a trace or jumper. If I wanted a read from each pair, where should I cut the traces? So, just to clarify, I will have two 1 ohm resistors, one for each pair, with one end connected to the trace, and the other...

Where would be the best spots for me to add (correct) bias test points for my 5150II? From what I could find out, pin 8 is where a bias probe checks the bias. I'm just not sure at which point to tie into to get a reading.