Bouncing tracks
- Thread starter VikingAxe
- Start date
bryan_kilco
Member
bryan_kilco
Member
When all these tracks play in your DAW, what is the master meter peaking at (with no fx on it)?
Also, what is each track peaking at? If you aim for like -18dB you should be ok.
Also, what is each track peaking at? If you aim for like -18dB you should be ok.
bryan_kilco
Member
bryan_kilco
Member
Don't quite understand the question.
I think the most common way is to render down your entire mix with nothing on the Master FX chain, then bring that rendered mix into a new session and master from there.
- Jul 21, 2009
- 68
- 1
- 6
ok...cool
im sending these tracks to a studio over the net tomorrow...ill let them worry about the mastering, etc. i just thought you could "bus" all the tracks to the master and have control over them that way.
either way, i followed your suggestion and brought everything down -10db. solved the problem. thanks man \m/
im sending these tracks to a studio over the net tomorrow...ill let them worry about the mastering, etc. i just thought you could "bus" all the tracks to the master and have control over them that way.
either way, i followed your suggestion and brought everything down -10db. solved the problem. thanks man \m/
bryan_kilco
Member
Is that only perceived because it's quieter now? Let the mastering engineer take care of that!
Skinny Viking
¯\(°_o)/¯ How do Lydian?
try turning your monitors up 1st and listen ... does it sound the same as you remember at a higher volume? If so, the change is only perceived because at the lower volume you're probably just hearing different frequencies poking out in spots that were masked or smoothed over by the increased volume you originally had
