- Apr 14, 2006
- 505
- 0
- 16
Here's six mics with two sets of clips. Clips are numbered and the clips with lc in the name have a bit of bottom compression.
mics are
57
57 w/o xformer
atm650
e609S
i5
atm25
I pointed each mic directly at the center of the same Greenback speaker, reamped the same clip and used a ruler laid across the speaker for the distance (See pic). No claim that this is a nat's ass measurement and I realize the diaphragms are not all the same distance due to the mic housing. but this allowed the setup to be very repeatable.
To get a really good feel for the tonal differences, I load a set of six into my DAW and loop a small selected section over and over, then switch to another clip of the same section. the differences jump out.
care to match clip to mic?
after a bit I'll post what's what.
336
337
338
339
340
341
336lc
337lc
338lc
339lc
340lc
341lc
mics are
57
57 w/o xformer
atm650
e609S
i5
atm25
I pointed each mic directly at the center of the same Greenback speaker, reamped the same clip and used a ruler laid across the speaker for the distance (See pic). No claim that this is a nat's ass measurement and I realize the diaphragms are not all the same distance due to the mic housing. but this allowed the setup to be very repeatable.
To get a really good feel for the tonal differences, I load a set of six into my DAW and loop a small selected section over and over, then switch to another clip of the same section. the differences jump out.
care to match clip to mic?
after a bit I'll post what's what.
336
337
338
339
340
341
336lc
337lc
338lc
339lc
340lc
341lc