Today I was tweaking my Sansamp Bass Driver DI and I noticed that when I´m turning the BLEND or DRIVE knob, sometimes comes a noise, like when you´re conecting a guitar cable... if I turn the knob carefully I can even find a spot where the pedal goes mute. It´s a very minor issue because, once I set the knobs, the pedal doesn´t produce these artifacts or goes mute unless I toch them again.
As I love this BDDI, today I went to a dude that fix amps and pedals to see if he could fix it just to make it 100%. The guy said that it´s pretty much impossible to open a Sansamp pedal (not only the BDDI) without breaking the circuit board, and altough the problem is an easy fix, there´s no way to reach the board because of the way they´re built and sealed.
Can anyone confirm or, hopefully, deny this information? I don´t know anything about this subject : /
As I love this BDDI, today I went to a dude that fix amps and pedals to see if he could fix it just to make it 100%. The guy said that it´s pretty much impossible to open a Sansamp pedal (not only the BDDI) without breaking the circuit board, and altough the problem is an easy fix, there´s no way to reach the board because of the way they´re built and sealed.
Can anyone confirm or, hopefully, deny this information? I don´t know anything about this subject : /
