Experimenting with Impulses (Feedback welcome)

[newamerikangospel]

https://drive.google.com/open?id=1SM42k444UoTWfW4w_ltVfapQ87gNsMq_

I am experimenting with impulses and wanted some feedback on them. The file naming is Mic>Preamp>Settings*>Cab>Speaker>Resonance-Presence setting. The mics are phase alligned, so should blend very easily (didn't check for phase allignment with the different Resonance-Presence settings.

*H for "hot" The preamp gain was higher with the output at 50%, Tone means Tone button engaged (the impedance was lowered)

 

[deLuther]

Just tried with my material.
Loaded IRs in my load box (St. ROCK REACT:IR, https://www.st-rock.com/React-IR/)
Used amp is pretty linear, so no need for passive mode.
Impulses better suited for preamp signal/solid state (flat) PA, because of huge resonance.
I think that R2-R4 in my case is overkill, R0 is OK, bu still have to reduce lows on amp.
Finally used mix of SM57 and e906 with 50% level.
Any phase related issues solved due to built-in Minimal Phase Transformation (i.e. MPT).

 

[newamerikangospel]

Thanks for checking these out. I didnt think about it until you posted your graphic, but the highpass on the 273 was engaged at 80hz, which has a pretty aggressive resonance peak. I will make a note to disengage that for future impulses.