Okay, I've got a guitar (cheap Jackson) with two full sized humbuckers, one tone pot, one volume pot and a three way selector switch.
I'm replacing the pickups and I want to wire it so that the tone pot only affects the neck pickup, other than that everything else stays the same. The question is: how should I modify the wiring to achieve this?
Here's the basic wiring diagram: http://dl.dropbox.com/u/1474550/sd/pickup_wiring_s0.jpg
I'm assuming this schematic corresponds to the original wiring in my guitar, where the pots act as a 'master' tone and volume controls. It's been ages since I've actually tried to understand a wiring schematic and just can't figure this out.
¯\(°_o)/¯
I'm replacing the pickups and I want to wire it so that the tone pot only affects the neck pickup, other than that everything else stays the same. The question is: how should I modify the wiring to achieve this?
Here's the basic wiring diagram: http://dl.dropbox.com/u/1474550/sd/pickup_wiring_s0.jpg
I'm assuming this schematic corresponds to the original wiring in my guitar, where the pots act as a 'master' tone and volume controls. It's been ages since I've actually tried to understand a wiring schematic and just can't figure this out.
¯\(°_o)/¯