Apollospeed said:
but, he's looking for outputs to go back into the amp.......not inputs, right ?
Those are on the X-Amp!!
http://www.radialeng.com/di-xamp.htm
http://www.radialeng.com/di-xamp-usage.htm
But which input or device did he use to record his Jackson with the Active EMG 81's?
And at what peak level did he record the input at?
http://presonus.com/pdf/fpmanual.pdf
Firepod Manual:
-Page 17-
CUE Mix Line Out. This outputs the results of the setting of the Mix knob on the front of the unit. The Mix
knob is a balance control between the inputs and the first two outputs.
Line Inputs/Preamp Outputs.
The FIREPOD features ¼” TRS balanced Send and Return jacks on Channels 1 and 2.
These jacks are labeled as Preamp Output (SEND) and Line Input (Return). These
connectors will accept either balanced (TRS – Tip Ring Sleeve) ¼” cables or unbalanced TS (Tip Sleeve)
¼” cables. These connectors allow the use of external processors such as reverbs, de-essers, limiters,
EQ’s, etc. Simply connect the Preamp Output jack, balanced or unbalanced to the input of the external
processor. Then connect the FIREPOD’s Line Input jack to the output of the external processor. The signal
is now routed out of the FIREPOD, into the external processor, then back into the FIREPOD. The final,
processed signal will be available to record now. The Line Input can also be used as a standard line level
input for devices that do not require pre-amplification (such as a CD player, drum machine, sampler and
etc.).
NOTE: The line inputs on channels 1 and 2 take precedence over the combo mic/Instrument inputs
on the front of the unit. If a cable is plugged into channel one line input on the rear of the
FIREPOD, then the mic/instrument input on channel one will be inactive until the cable is removed
from line input 1.
Firepod Manual:
-Page 18-
4 . 2
USING THE PREAMP OUTPUT / LINE INPUT AS AN INSERT
The FIREPOD features ¼” TRS balanced Send and Return jacks on Channels 1 and 2. These jacks are
labeled as Preamp Output (SEND) and Line Input (Return). These connectors allow the use of external
processors such as reverbs, de-essers, limiters, EQ’s, etc. Simply connect the Preamp Output jack, balanced
or unbalanced to the input of the external processor. Then connect the FirePod’s Line Input jack to the output
of the external processor. The signal is now routed out of the FIREPOD, into the external processor, then back
into the FIREPOD. The final, processed signal will be available to record now. The Line Input can also be used
as a standard line level input for devices that do not require preamplification (such as a CD player, drum
machine, sampler and etc.).
NOTE: The line inputs on channels 1 and 2 take precedence over the combo mic/Instrument inputs
on the front of the unit. If a cable is plugged into channel one line input on the rear of the
FIREPOD, then the mic/instrument input on channel one will be inactive until the cable is removed
from line input 1.