Voxengo Boogex and Impulse Question

[_Protoss_]

Hi...I'm a newbie about loading impulses to my stufs, and i have a
little problem.
After of load the impulse into Boogex (Engl V30's) and play it, I have
constant Drop outs , pops and clicks during the reproduction...and, my question is, what things should I care for prevent this kind of troubles??

My Chain is DI > Waves C1 > TSS > Wagner MK II > Boogex > C4

Thanx for read!
Cheers!

 

[Unavailable]

Sounds like your computer can't handle the load you're trying to give it. What are your specs?

 

[_Protoss_]

Intel Core 2 Duo 2.2 (Santa Rosa), 3GB Ram (667mhz Bus) and Mbox 2

I am constantly changing the size of the buffer, but apparently the
problem is not that

 

[Unavailable]

Intel Core 2 Duo 2.2 (Santa Rosa), 3GB Ram (667mhz Bus) and Mbox 2

I am constantly changing the size of the buffer, but apparently the
problem is not that

Well that's definitely not the problem... It's possible that your hard drive is having a hard time keeping up with the audio... However I really only get dropouts when I have too many plugs running on my older P4 rig.

Edit: Do you have your DAW setup to support multicore processing? Or does it do it natively or anything?

 

[Soundlurker]

So you have them at the highest buffer level, too? What interface are you using? Also try lowering the output of wagner just in case it turns out it was clipping because boogex is increasing the level a bit.

 

[Sloan]

Yeah, that sounds weird, I run boogex with no problems on
-AMD Athlon 64 3000+ 2.0 GHz
-2g DDR RAM (not ddr2, brah)
-presonus firestudio project

 

[-Noodles-]

Try it without the Waves and C4.. make any difference?

 

[_Protoss_]

Yea, C4 is in the end of the Chain.

I found the trouble...the MKII output was the problem. Was too high , but definitly I decide not using more Voxengo EQ because, even when the levels are low, the damn thing give me drop outs from nowhere, setting a normal curve eq

Thanx all for your help!

Regards!